. Inspect or replace brake pads
. Check/replace the engine oil and replace oil filters
. Check if rubber boots are cracked and need replacement
. Inspect or replace windshield wipers
. Check or refill windshield washer fluid
. Inspect tires for pressure and wear
. Tire balancing and rotation
. Wheel alignment
. Check, clean or replace battery terminals and top up battery fluid
. Check or flush transmission fluid
. Check and test electronics, e.g., Anti-lock braking system or ABS
. Check or flush brake fluid
. Inspect or replace spark plugs
. Check or flush power steering fluid
. Check and flush engine coolant
. Inspect or replace air filter
. Inspect or replace timing belt and other belts
. lubricate locks, latches, hinges
. Check all lights
. Tighten chassis nuts and bolts
. Check/replace fuel filters
. Car wash.
π¨ Comment
#️⃣ Articles
. Check/replace the engine oil and replace oil filters
. Check if rubber boots are cracked and need replacement
. Inspect or replace windshield wipers
. Check or refill windshield washer fluid
. Inspect tires for pressure and wear
. Tire balancing and rotation
. Wheel alignment
. Check, clean or replace battery terminals and top up battery fluid
. Check or flush transmission fluid
. Check and test electronics, e.g., Anti-lock braking system or ABS
. Check or flush brake fluid
. Inspect or replace spark plugs
. Check or flush power steering fluid
. Check and flush engine coolant
. Inspect or replace air filter
. Inspect or replace timing belt and other belts
. lubricate locks, latches, hinges
. Check all lights
. Tighten chassis nuts and bolts
. Check/replace fuel filters
. Car wash.
HOW TO JUMP-START YOUR CAR:
ReplyDeleteA jump-start is a method of starting a vehicle or other vehicle powered by an internal combustion engine when the vehicle’s battery has been discharged.
-Open the bonnet, and check the physical condition of the battery
-Turn off all the electrical accessories
- Connect one jumper cable to the positive (+) on your battery. Connect the other end to the positive (+) terminal on the booster battery.
- Connect the second jumper cable to the negative (-) terminal on the booster battery.
- Start the vehicle, once the vehicle is running, disconnect the negative (-) & positive (+) cable from your vehicle then from the booster battery... - Courtesy– Automedics limited